Please use this identifier to cite or link to this item:
http://repo.uipa.edu.ua/jspui/handle/123456789/9026
Title: | Розробка електродів для наплавлення робочої частини металорізального інструменту |
Other Titles: | Development of electrodes for surfacing the working part of a metal-cuttingtool |
Authors: | Ізотова, К. О. Izotova, E. |
Keywords: | wear resistance hardness alloying arc surfacing electrodes metal cutting tool зносостійкість електроди легування дугове наплавлення металоріжучий iнструмент твердiсть |
Issue Date: | 2019 |
Publisher: | УІПА |
Citation: | Ізотова К. О. Розробка електродів для наплавлення робочої частини металорізального інструменту / К. О. Ізотова // Машинобудування : зб. наук. пр. / Укр. інж.-пед. акад. - Харків, 2019. - № 24. - С. 66-73. |
Series/Report no.: | № 24; |
Abstract: | The purpose of the work is to extend the service life of metal cutting tools by surfacing with alloyed electrodes W, C, B, Ti and rare-earth metals (REM), to increase the heat resistance and wear resistance of the cutting and stamping tools.Electrodes were made from Sv-08A wire with rutile-fluorocarbon coating. Ferromanganese and ferrotitanium were used as deoxidants. Chromium, molybdenum and vanadium were introduced in the form of ferroalloys, and carbon in the form of silver graphite and silicon carbides, titanium and tungsten. In order to reduce the cost of electrodes, carbides W, Ti, Si, as well as cobalt were introduced into the charge of the coating in the form of waste from sharpening carbide tools from alloys T30K4, T15K6, VK8, etc.The coating was applied to the rods by a press method. For research did surfacing size 80x20x20 mm.The hardness of the deposited metal was checked on the surface of the eight-layer surfacing, made to control the chemical composition of the deposited metal.The surfacing for hardening was carried out in a salt chlorobarium bath to a temperature of 1225 ° C. The exposure at this temperature was 20 min. Quenching was carried out in oil.The study of the cutting properties of surfacing was carried out using the end turning method.The No1 electrode is designed for wear-resistant surfacing of cutting edges of cut dies. Electrode No. 3 is intended for surfacing of edged dies.. No2 electrode for surfacing the working part of cutters and knives for metal cutting. The wear resistance of the cutters surfaced by the No2 electrode is not inferior to the cutters made of P6M5 steel. The resistance of the cut matrices from steel 45 with the proposed surfacing is 8-10 times higher compared to the matrices from 5XHM steel. |
URI: | http://repo.uipa.edu.ua/jspui/handle/123456789/9026 |
ISSN: | 2079-1747 |
Appears in Collections: | Машинобудування (Збірник наукових праць) |
Files in This Item:
File | Description | Size | Format | |
---|---|---|---|---|
admin-jmash,+66-73.pdf | DOI 10.32820/2079-1747-2019-24-66-73 | 270,14 kB | Adobe PDF | View/Open |
Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.